Нашёл, откуда инфа про 30 минут. Вот документация по Scion tC 2007.
http://forum.scionclub.ru/pdf/RM/RM0...obilizer.pdf#6
Так и написано, что при замене EСM надо:
Register the ECU COMMUNICATION ID.
(1) Using SST, connect terminals TC and CG of the DLC3.
(2) Turn the ignition switch ON (do not start the engine) and leave it as is for 30 minutes.
(3) Turn the ignition switch OFF and disconnect terminals TC and CG.
(4) Check that the engine starts
Но там отдельный Transponder key ECU, поэтому и нужна такая синхронизация между ними, а в V30 он находится внутри ECM.
В мануале на 30-ку описаны действия при замене ECM:
1. KEY REGISTRATION IN AUTOMATIC REGISTRATION
(a) Registration of a new transponder key.
- This must be done when you install a new ECM.
- The new ECM is in the automatic key code registration mode. The number of key codes for this
ECM is already fixed, and so it can be registedered.
On this type of vehicle, up to 3 key codes can be registered.
- In the automatic registration mode, the key registered last becomes the sub–key.
73_Theft_Deterrent_and_Door_Lock.pdf
У меня техстрим есть. Может, как-то можно сбросить блок ECM в такой режим.